Good Day All;
Quick Question - I was collecting data on the " Ghost" near Navi but the SharpCap gain slider that I always pull down to "0" stopped at "2" and I didn't notice it for a few hours - can I still apply those frames (successfully) against bias and darks taken at "0" in WBPP? Is that tiny difference detrimental? Will it even be accepted and allowed to run in WBPP?
Thanks for any advice !
Pete
|
You cannot like this item. Reason: "ANONYMOUS".
You cannot remove your like from this item.
Editing a post is only allowed within 24 hours after creating it.
You cannot Like this post because the topic is closed.
As far as I know, WBPP doesn't check for gain. You should be safe there. Also, if your sensor doesn't have any substantial amp glow, you should be fine. Just test it.
cheers,
Wim
|
You cannot like this item. Reason: "ANONYMOUS".
You cannot remove your like from this item.
Editing a post is only allowed within 24 hours after creating it.
You cannot Like this post because the topic is closed.
Wim van Berlo: As far as I know, WBPP doesn't check for gain. You should be safe there. Also, if your sensor doesn't have any substantial amp glow, you should be fine. Just test it.
cheers,
Wim Thanks! It's running now!
|
You cannot like this item. Reason: "ANONYMOUS".
You cannot remove your like from this item.
Editing a post is only allowed within 24 hours after creating it.
You cannot Like this post because the topic is closed.
to create to post a reply.